All related DIY information is inside.
Where to aquire DIY PCBs
New Renard SS Controllers
05-02-2009 05:33 PM
Just thought I'd share what I've been up too, since I finally figured out the whole driver/power thingie. Basically a stripped out 300w fixture w/3w...
Greg, PondDude, on the LOR board will be selling something that's new. Check out the thread on the LOR Forum:...
The introduction of Blizzard was greater then any of us could have expected. We sold out of the initial purchase of boards in about two weeks. ...
William asked about possibly making a telephone interface for his display. I did a little googling and came up with something that might work. Here...
Well I got a DIY PC board as a door prize at the Charlotte mini. Robert Jordan (RJ) and a couple other folks did a great job of presenting what was...
I use Measurement Computing DIO cards in my display to control things I only need on/off switching for. When first designing a way to get the outputs...
I have a couple questions on DIO cards.. Who's DIO card works with LOR? I assume the DIO puts out an analog 0-10v signal, is this correct?
12 channel RF remote... Time to wire up some input triggers...
New to this forum, and a few others for that matter... I have ran a few searches here and there and quite frankly can not find what I'm looking for -...
I'm not sure if this belongs here or in the Showing Off section, but I wanted to introduce my new DIY controller. The Prop 128 v2 Light...
Once again welcome to wjohn, the DIY and PCB section moderator. Jeff
Hi, I asked William to provide a place for DIY for a couple reasons. First LOR now supports DMX and that bridged the gap between DIY and...
Use this control to limit the display of threads to those newer than the specified time frame.
Allows you to choose the data by which the thread list will be sorted.
Order threads in...
Note: when sorting by date, 'descending order' will show the newest results first.
Forum Rules
